(a) Consider an 8085 based system operating with the following specification:…

PYQ GATE 1991Modified — slightly modified from the official paper; see the solution

(a) Consider an 8085 based system operating with the following specification:

Crystal frequency : 6 MHz

ROM map : 0000 through 07FF

RAM map : 1000 through 17 FF:

ROM requires one wait state.

RAM requires no wait state.

Determine the instruction cycle time for each of the following instructions:

(i) ORI 22H

(ii) DCR M

Assume all instructions and immediate bytes are fetched from ROM, the 8085 READY signal inserts one wait state into each ROM memory-read machine cycle, and all I/O control signals use the active-low polarities drawn in the timing diagram. Assume the following initial conditions of the CPU registers (in hex) for each of the instructions:

A = 55, B = AA, C = F7, D = 10, H = 10, L = FF, PC = 0200, SP = 17F0.

(b) Developing an output port interface (draw a block schematic) for an 8085 based system with a demultiplexed address bus which incorporates a handshake protocol as per the timing diagram given in figure. The interface should include a status input port at I/O address 40H which reads the INTERRUPT and BUFFFULL signals through the most significant bit and the least significant bit, respectively. The output data port is at the same I/O address 40H and is activated by a write operation. Assume the availability of SSI and MSI level components only.

Write a short program segment which performs a 200 H byte programmed I/O data transfer to the device from memory address 3400 H,

Handshake timing diagram showing port data, active-low write to port 40H, INTERRUPT, BUFFFULL, and active-low device STROBE.

Sign up free to check your answer

Sign up free

Explore the full course: Zero To Hero

Loading lesson…