A D flip-flop is to be connected to an 8085 microprocessor chip as a 1-bit…

PYQ GATE 1997

A D flip-flop is to be connected to an 8085 microprocessor chip as a 1-bit output port with a port address of FF hex. Data bit D3 should be involved in the data transfer from CPU to the flip-flop. The flip-flop should be cleared on power ON.

(a) Using only one NAND gate (fan in of 10), one NOT gate and one D flip-flop, draw the required interface logic circuit (only the relevant signals should be shown).

(b) Write a program to generate a square wave on the output of the flip-flop. ON and OFF periods of the square wave should be 7 bus cycles each.

Sign up free to check your answer

Sign up free

Explore the full course: Zero To Hero

Loading lesson…